Fibreglass Pool Ideas Taradale
Fibreglass pool ideas for Taradale — one-piece shells, built in New Zealand.
We manufacture the shell, Think Water puts it in. That is the whole model behind a Bayside fibreglass pool in Taradale: built in Whakatāne, installed on site by the licensed local installer who covers Napier, Hastings, Waipukurau and the wider region.
At a glance
Sizes are quoted as internal, water-line measurements — an 8 x 4 is 8 x 4 of water. Depth is the shell height, and capacity is measured to the top of the shell.
The photo up top
What to look at in a pool photo
That is a finished Bayside pool, and it is the best way we can show you what one looks like in a yard — it is not a photo of a section in Taradale. Look at how much room the pool takes out of the space around it, where the water line sits when you look out from the house, and what the yard looks like once the paving and planting are done. For an in-ground fibreglass pool in Taradale, those three decide it.
- How the pool sits in the section Start from the space you actually have. The shell is only part of the footprint once the surround and somewhere to walk have taken their share, and that arithmetic decides what fits in Taradale long before the model does.
- The colour of the water The water takes its colour from the finish on the shell, and it is the one choice on the whole build you look at every day. Worth seeing a finished pool rather than a swatch before you commit.
- What surrounds it Paving, decking and glass fencing are what turn a shell in the ground into a yard. They are priced and chosen separately from the pool itself, and getting them settled early keeps the build moving.
Want to see one in the ground rather than a photo of one? Think Water installs right across Hawke’s Bay — give them a call and ask. Every shell they set was moulded in our own factory first.
Before you commit
What to work out first, Taradale
Every decision on a Taradale pool comes back to four questions — how much clear space you have, how the pool will actually be used, how the shell gets to the hole, and what happens around the water. Settle those and the rest follows.
Space on the section
Measure the clear space first — the pool, the surround you want, and room to walk around it. We usually start from what actually fits and work back to the model.
How you will use it
Decide who swims and how. Small children, teenagers, laps, or two adults and a glass of wine at the end of the day all point at different models and different depths.
Getting it in
Access is the question that decides most installs. Machines need a clear run to the hole, or the shell goes over the house by crane — worth checking before you set your heart on a position.
Around the pool
What goes around the pool is a separate purchase and usually a later one. Copings, the surround, fencing and landscaping are worth planning at the same time as the pool even when they are bought later.
One thing, three names
Three names for the same thing
The words get used interchangeably — swimming pool, in-ground pool, fibreglass pool — so it is worth being precise about what you are buying.
In-ground pool
A pool set into the ground rather than standing above it. Every Bayside shell is designed to go in the ground, so an in-ground pool is the normal case rather than an upgrade. Where digging is not wanted, there is also a Freestanding option in the range — still a Bayside shell, sitting above ground.
Fibreglass pool
Fibreglass means the pool body is a one-piece moulded shell, made in our Whakatāne factory and delivered complete. On site the work is preparing the base, placing and setting the shell, then everything around it — rather than building the pool body itself on site.
Swimming pool
The widest of the three, and the one people type most. It covers a small plunge pool through to a 12 m family and lap pool — the difference being length, depth and how much of the section they take up.
On the numbers: the size you are quoted is the water-line size, not the outside of the shell. An 8 x 4 pool gives you 8 x 4 of water. Depth is the height of the shell, and volume is measured to the top of the shell. That is true of every inground pool we build, whatever spelling you searched.
What fits
The size range, smallest to largest
Ten fibreglass swimming pool models cover it. At the small end: the 3.6 x 2.2 m Tranquil and the 4 x 2.4 m Pause. Mid-range: the 5.45 x 3.4 m Element, the 6.5 x 3 m Retreat and the 7 x 3.5 m Cove. Larger: the 8 x 4 m Satin, the 9 x 4.4 m Shoreline, the 10 x 4.4 m Coastline and the 12 x 4.4 m Big Bertha. Every one is moulded in Whakatāne. Sizes are quoted as internal water-line dimensions, so an 8 x 4 really is 8 x 4 of water, depth is the shell height, and capacity is measured to the top of the shell.
The sequence
The sequence of a pool build in Taradale
No two sites are the same, but the order is. This is the shape of a Bayside fibreglass pool install.
- Site assessment — your section is looked at before anything is dug: where the pool can go, how the machines reach the hole, where the shell can be placed.
- Design and quote — the model and size that fit, and a written price. Get the quote in writing and itemised, so you can see exactly what you are paying for.
- Manufacture — the shell is moulded in Whakatāne, in New Zealand, under our own roof.
- Excavation and base — the hole is dug, the base is prepared properly, and the shell is set by the same team that quoted the job.
- Fill and commission — water goes in, the filtration and pump are commissioned, and the pool is running.
- Handover — you get the pool handbook, which sets out how to look after the shell.
The fast part is the dig and the shell going in. The slow part is the water, the surrounds and the fence — plan for that, not for the dig.
Looking after it
Once the pool is in
On handover day we walk you through the whole pool — the equipment, the water and what the first week looks like — so it is familiar before we leave. After that the main job is the water: keep the chemistry in range and the surface and the equipment both stay happy.
Read the pool warranty Pool maintenance tips Landscaping around a pool
The rest of the region
If you are elsewhere in Hawke’s Bay
One team looks after this region: Think Water, covering Napier, Hastings, Waipukurau and the wider region. These are the other areas with their own pool ideas pages.
Questions
Questions about a pool in Taradale
How much does a fibreglass pool cost in Taradale?
It depends on the model, the size, how easily the shell reaches your section, and what you put around the pool — those four things move the number more than anything else. We do not quote a figure without seeing the site, because a wrong number wastes your time and ours. The pool cost guide carries the bands our own written quotes run across; your installer writes the actual price for your section. Send us your section and you will get a written quote for it.
What size pool suits a Taradale section?
That is a question about your section, not about Taradale in general — the clear space is what decides it. The fibreglass swimming pool range starts at the 3.6 x 2.2 m Tranquil plunge pool and runs to the 12 x 4.4 m Big Bertha, with ten models in between. A tight section usually ends up at a plunge or compact model; a section with room usually takes a 7 to 8 metre family pool. Worth remembering that our sizes are internal, water-line measurements, so an 8 x 4 pool gives you 8 x 4 of water, and the shell needs a little more space than that.
What consents does a pool need in Taradale?
Pool fencing is the part that is not optional. It has to comply with the building code, and it is checked — that applies to any pool in Taradale, whether the pool itself needed a consent or not. Depending on the section, a resource or building consent may also come into it. We work through that as part of the job rather than leaving you to work it out, and the fencing sits outside the pool price, so ask for it to be shown on the quote.
How long does a pool installation take?
The excavation and the shell placement are the quick part — usually a few days once the team is on site. What takes the time is what comes after: filling, surrounds, fencing and getting the water balanced. You get a realistic sequence up front rather than just the fast part, so you can plan the garden and the fencing around it.
What is the most popular Bayside pool in Taradale?
It follows the sections rather than the postcode. Where space is tight, the plunge and compact models win — the Tranquil, the Pause and the Element. Where there is room, a 7 to 8 metre family pool is the usual pick, which is the Retreat, the Cove or the Satin. The whole range with its dimensions is on the pool range page if you want to see the sizes side by side before you ring anyone.
Who installs a Bayside pool in Taradale?
We manufacture, and a licensed local pool builder and installer puts the pool in. For this region that is Think Water, covering Napier, Hastings, Waipukurau and the wider region. Every Bayside shell is moulded in our Whakatāne factory and installed on site by the installer who covers your area, and the person who quotes your job is the person on your site when it goes in.
Are fibreglass pools in-ground pools?
Yes — a Bayside shell is designed to be set into the ground, so an in-ground pool is the standard case rather than a special order. The range also includes a Freestanding option for a section where digging is not wanted; it is the same shell family, sitting above ground.
What is different about a fibreglass pool?
The shell arrives as one finished piece rather than being built up on site, so the on-site work is preparing the base, placing and setting it, and everything around the water. That is also why the surface matters so much: ours is ChlorShield, the gelcoat system on every Bayside shell, and the ChlorShield page sets out what it is built to do. We will talk about any pool type with you — we just sell the one we manufacture.
Can I see the pool colours before I commit?
Yes. There is a colours page with the full palette and real pools photographed in each colour, and you can ask to see the colour in person before anything is ordered. Colour is the one choice that is purely about what you like, so it is worth taking your time over.
Let us price a pool for your Taradale section
Tell us where the pool is going and we will put the models and sizes that fit in front of you, with a written price.