Fibreglass Pool Ideas Gisborne

In-ground fibreglass pools and swimming pool ideas for Gisborne backyards.

Fibreglass pool ideas for Gisborne

Fibreglass pools made in New Zealand, installed on site by the local installer who covers Gisborne and the East Coast. Below is how it works for Gisborne, what changes the price, and the questions people ask before they commit.

At a glance

Pool models10
Built inWhakatāne
Your installerGCL
CoversGisborne

Sizes are quoted as internal, water-line measurements — an 8 x 4 is 8 x 4 of water. Depth is the shell height, and capacity is measured to the top of the shell.

The photo up top

What to look at in a pool photo

That is a finished Bayside pool, and it is the best way we can show you what one looks like in a yard — it is not a photo of a section in Gisborne. Look at how much room the pool takes out of the space around it, where the water line sits when you look out from the house, and what the yard looks like once the paving and planting are done. For an in-ground fibreglass pool in Gisborne, those three decide it.

  1. The real size of the thing A pool looks smaller on paper than it does in a section. Use the picture to judge the length you want against the space you have — the difference between a 6.5 m and a 9 m swimming pool is obvious in a photograph and invisible in a spec sheet.
  2. One piece of water Every Bayside shell is moulded as a single piece before it leaves Whakatāne, so the pool arrives complete and the water line is continuous. Nothing is built up on site out of panels or a liner.
  3. The finishing decisions The pool is the start of the job, not the end of it. Fencing, paving or decking, and the planting around it, are what you notice in a picture of a finished yard — and they are worth deciding while the section is still open ground.

Want to see one in the ground rather than a photo of one? GCL installs right across Gisborne — give them a call and ask. Every shell they set was moulded in our own factory first.

The Gisborne version

Picking the right fibreglass pool in Gisborne

Start with your own section, not with a brochure. The four points below are the ones that decide which fibreglass pool model makes sense at your place.

Space on the section

The pool is only part of the footprint. Add the surround, the fence line and access to the pump equipment, then see what is left for water.

How you will use it

Decide who swims and how. Small children, teenagers, laps, or two adults and a glass of wine at the end of the day all point at different models and different depths.

Getting it in

Access is the question that decides most installs. Machines need a clear run to the hole, or the shell goes over the house by crane — worth checking before you set your heart on a position.

Around the pool

Paving, decking, fencing and planting are what make it look finished. We can price the pool and the surrounds together so there are no surprises.

One thing, three names

What people mean by an in-ground pool

Worth two minutes, because swimming pool, in-ground pool and fibreglass pool carry slightly different promises.

In-ground pool

A pool set into the ground rather than standing above it. Every Bayside shell is designed to go in the ground, so an in-ground pool is the normal case rather than an upgrade. Where digging is not wanted, there is also a Freestanding option in the range — still a Bayside shell, sitting above ground.

Fibreglass pool

Fibreglass means the pool body is a one-piece moulded shell, made in our Whakatāne factory and delivered complete. On site the work is preparing the base, placing and setting the shell, then everything around it — rather than building the pool body itself on site.

Swimming pool

The widest of the three, and the one people type most. It covers a small plunge pool through to a 12 m family and lap pool — the difference being length, depth and how much of the section they take up.

One thing worth knowing about the sizes: the dimensions we sell are internal, water-line measurements — an 8 x 4 is 8 x 4 of water. Depth is the shell height, and capacity is measured to the top of the shell. Whether you type inground pool or in-ground pool, this is the pool that goes in the ground.

What fits

Fibreglass pool sizes for a Gisborne section

The fibreglass swimming pool range runs from the 3.6 x 2.2 m Tranquil and the 4 x 2.4 m Pause — plunge pools that fit a courtyard — through the 5.45 x 3.4 m Element, the 6.5 x 3 m Retreat and the 7 x 3.5 m Cove, and up to the 8 x 4 m Satin, the 9 x 4.4 m Shoreline, the 10 x 4.4 m Coastline and the 12 x 4.4 m Big Bertha. Ten models, one shell family, all built in Whakatāne. The sizes we sell are internal, water-line measurements — an 8 x 4 is 8 x 4 — so what you are quoted is what you get to swim in.

See the full fibreglass pool range and dimensions

The sequence

How a Gisborne pool goes in, step by step

No two sites are the same, but the order is. This is the shape of a Bayside fibreglass pool install.

  1. Site visit — assess the section, the access and the position. This is the step that prevents surprises later.
  2. Design and price — the model suited to the section, with a written quote you can read line by line.
  3. Manufacture in Whakatāne — one-piece fibreglass shell, built here rather than imported complete.
  4. Excavate and prepare the base — the part that is invisible afterwards, and the part that matters most.
  5. Set the shell and backfill — placed, levelled and set in.
  6. Fill, commission, hand over — the pool running, and the handbook with it.

Excavation and shell placement are quick. What takes the time is everything after: filling, surrounds, fencing and getting the water balanced.

Looking after it

Looking after a fibreglass pool after handover

On handover day we walk you through the whole pool — the equipment, the water and what the first week looks like — so it is familiar before we leave. After that it is ordinary care: chemistry in range, the filter looked after, and the pool stays the way it did when we handed it over.

Read the pool warranty   Pool maintenance tips   Landscaping around a pool

The rest of the region

Other Gisborne areas we build pool ideas for

GCL is the local pool builder and installer for Gisborne and the East Coast, so these pages sit alongside yours rather than instead of it. The team that would quote a Gisborne pool is the one on the Gisborne page.

Questions

Fibreglass pool FAQs for Gisborne

What does a swimming pool cost in Gisborne?

It depends on the model, the size, how easily the shell reaches your section, and what you put around the pool — those four things move the number more than anything else. We do not quote a figure without seeing the site, because a wrong number wastes your time and ours. The pool cost guide carries the bands our own written quotes run across; your installer writes the actual price for your section. Send us your section and you will get a written quote for it.

How big a pool fits in Gisborne?

That is a question about your section, not about Gisborne in general — the clear space is what decides it. The fibreglass swimming pool range starts at the 3.6 x 2.2 m Tranquil plunge pool and runs to the 12 x 4.4 m Big Bertha, with ten models in between. A tight section usually ends up at a plunge or compact model; a section with room usually takes a 7 to 8 metre family pool. Worth remembering that our sizes are internal, water-line measurements, so an 8 x 4 pool gives you 8 x 4 of water, and the shell needs a little more space than that.

What consents does a pool need in Gisborne?

Pool fencing is the part that is not optional. It has to comply with the building code, and it is checked — that applies to any pool in Gisborne, whether the pool itself needed a consent or not. Depending on the section, a resource or building consent may also come into it. We work through that as part of the job rather than leaving you to work it out, and the fencing sits outside the pool price, so ask for it to be shown on the quote.

How long does a pool installation take?

The excavation and the shell placement are the quick part — usually a few days once the team is on site. What takes the time is what comes after: filling, surrounds, fencing and getting the water balanced. You get a realistic sequence up front rather than just the fast part, so you can plan the garden and the fencing around it.

Which Bayside model should I look at first?

It follows the sections rather than the postcode. Where space is tight, the plunge and compact models win — the Tranquil, the Pause and the Element. Where there is room, a 7 to 8 metre family pool is the usual pick, which is the Retreat, the Cove or the Satin. The whole range with its dimensions is on the pool range page if you want to see the sizes side by side before you ring anyone.

Do you cover Gisborne?

We manufacture, and a licensed local pool builder and installer puts the pool in. For this region that is GCL, covering Gisborne and the East Coast. Every Bayside shell is moulded in our Whakatāne factory and installed on site by the installer who covers your area, and the person who quotes your job is the person on your site when it goes in.

Are fibreglass pools in-ground pools?

Yes — a Bayside shell is designed to be set into the ground, so an in-ground pool is the standard case rather than a special order. The range also includes a Freestanding option for a section where digging is not wanted; it is the same shell family, sitting above ground.

What is different about a fibreglass pool?

The shell arrives as one finished piece rather than being built up on site, so the on-site work is preparing the base, placing and setting it, and everything around the water. That is also why the surface matters so much: ours is ChlorShield, the gelcoat system on every Bayside shell, and the ChlorShield page sets out what it is built to do. We will talk about any pool type with you — we just sell the one we manufacture.

Can I see the pool colours before I commit?

Yes. There is a colours page with the full palette and real pools photographed in each colour, and you can ask to see the colour in person before anything is ordered. Colour is the one choice that is purely about what you like, so it is worth taking your time over.

Ready to talk about a fibreglass pool in Gisborne?

Tell us where the pool is going and we will put the models and sizes that fit in front of you, with a written price.

← Previous areaPool Ideas East Coast
Bayside Pools Gisborne — James, GCL Gisborne
Next area →Pool Ideas Te Puia Springs